Easter & Bank Holiday Information: Kitronik is closing for the Easter bank holidays, orders placed after the Thursday cut off will ship Tuesday 2nd April.

How to Use the Wall Mount PSU with LED Strips

Electrician’s Guide to using the wall mount 12V 5A power supply with LED strips

 

how_to_use_the_wall_mount_psu_with_led_strips_01

Overview

This is a guide aimed at people who have experience working with mains electricity and are aware of the safety precautions that must be taken when working with high voltage electricity. It describes how to use the wall mount power supply to power up to 10M of LED strips. DO NOT ATTEMPT TO WIRE ANYTHING INTO THE MAINS IF YOU ARE NOT QUALIFIED – SERIOUS INJURY MAY OCCUR.

You will need:

Step 1

how_to_use_the_wall_mount_psu_with_led_strips_02

Identify the (brown) live and (blue) neutral wires on the AC side of the terminal. These can be connected directly to a light fitting or into a plug if you prefer.

Step 2

how_to_use_the_wall_mount_psu_with_led_strips_03

You can connect the plug on the DC end into a 2.1mm 5A rated DC socket, as these are far more expensive than the low current version we recommend cutting the 2.1mm plug off and running the two wires into a 2-way terminal block.

Step 3

how_to_use_the_wall_mount_psu_with_led_strips_04
Connect the positive and negative terminals on your terminal block to the corresponding positive and negative pads on the LED strip. If you are using a full strip then wires will already be attached to one end so you can wire these straight into your terminal, noting the polarity indicators where the wires enter the LED strip. The pads are labelled with + and – signs as can be seen in the image above.

Connecting LED strips in parallel

If you wish to use multiple LED strips exceeding a total length of 5M you must connect them to your power supply in parallel as shown in the diagram below. how_to_use_the_wall_mount_psu_with_led_strips_05 Notes
  • Cut lines are marked every 5cm along the LED strips, if you wish to shorten a strip make sure you cut down the line and don’t damage the copper pads.
  • If you are connecting lengths of LED strips in series do not exceed 5m.
  • You can power a maximum of up to 12m of single colour LED strips from a single 5A PSU if they are run in parallel.
  A printable PDF of this guide can be downloaded here pdf_icon.gif Learn more about the author

Leave a comment

All comments are moderated before being published