Easter & Bank Holiday Information: Kitronik is closing for the Easter bank holidays, orders placed after the Thursday cut off will ship Tuesday 2nd April.

Electronics Projects Tutorials
Kitronik University This Kitronik University resource lists our Electronics Projects Tutorials. Some are made using our electronic project kits, whilst others are built from scratch.

Contents:

Once built, a Miniature 3V motor vibrates the body of the Vibrobug, causing it to scurry across tables.
Our mono amplifier can easily be converted to work as a practice guitar amplifier.
Our mono amplifier this time converted to work as a practice guitar amplifier with volume control.
A simple circuit from scratch using a transistor to vary the brightness of a bulb.
By simply adding a battery holder and light bulb to a to our light activated switch kit (built in dark activated configuration) you can create a garden light that automatically comes on in the dark.
By adding a battery holder, switch and buzzer to our light activated switch kit (built in light activated configuration) you can create an alarm that sounds when a dark draw is opened.
Two of our  light activated switch kits and two motors and you have a simple buggy.
Our heat activated kit adapted to detect if a babies bath water is too hot.
Use our heat activated kit and a motor to make a heat activated fan..
Two of our kits combined to make an electronic dice.
Use a 12V DC power supply with our mono amplifier project kit.
Many of our project kits can be adapted to run from a power supply with a power LED.
Our 12V wall mount power supply can be used to run any of our LED strips.
Connect a servo to a PICAXE control chip and run your first program.
Use our colour changing LED kit to add a bit of bling to a simple 3D printed Christmas tree.
There are few simpler projects than this great electronic version of a candle.

2 comments

Mark Donnison

Mark Donnison

Hi Colin, without knowing the dimensions it is difficult to give you a useful answer. If there is room in your project, a micro:bit can be coded to do exactly what you outlined above.

Colin Ellis

Colin Ellis

Hi, I am VERY inexperienced where electronics are concerned but I am trying to design a very small flashing/strobe LED system that is triggered by either a shock (hard landing) or by a timer (30 seconds etc) is there something available or a design you have that would suit. The size is crucial as this must fit into something extremely small. Many thanks, Colin

Leave a comment

All comments are moderated before being published