This is LilyPad Arduino - the main board consisting of an ATmega328 with the Arduino bootloader and a minimum number of external components to keep it as small (and as simple) as possible. Board will run from 2V to 5V. The latest version of the LilyPad supports automatic reset for even easier programming. The back side of the LilyPad is now completely flat! We now use a surface mount programming connector to keep the header from poking through.
This version of the LilyPad now uses the new ATmega328 at 8MHz. Arduino 0016 supports the Arduino Pro Mini 328/8MHz. Use this setting when using this new LilyPad 328.
LilyPad is a wearable e-textile technology developed by Leah Buechley and cooperatively designed by Leah and SparkFun. Each LilyPad was creatively designed to have large connecting pads to allow them to be sewn into clothing. Various input, output, power, and sensor boards are available. They're even washable!
- 50mm outer diameter
- Thin 0.8mm PCB
Excl. VAT: £7.95 Incl. VAT: £9.54
Conductive thread can be used like conventional sewing thread, however...
Excl. VAT: £2.40 Incl. VAT: £2.88
A USB 2.0 type A to Mini-B 5-pin cable. Use this with the FTDI Basic P...
Excl. VAT: £5.50 Incl. VAT: £6.60
This is a small buzzer for the LilyPad system. It uses 2 I/O pins on t...
Excl. VAT: £12.00 Incl. VAT: £14.40
This is a Three Axis Accelerometer for the LilyPad system. Based on th...
Excl. VAT: £5.20 Incl. VAT: £6.24
This is a simple to use Light Sensor that outputs an analog value from...
Excl. VAT: £1.50 Incl. VAT: £1.80
A LilyPad Micro is like a smaller version of the LilyPad LED board. Th...