Clearance prices shown in orange are in GBP and exclusive of VAT.
The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip providing a network (IP) stack capable of both TCP and UDP. The Arduino Ethernet Shield supports up to four simultaneous socket connections. Use theEthernet libraryto write sketches which connect to the internet using the shield.
The ethernet shield connects to anArduino boardusing long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.
The latest revision of the shield adds a micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino Duemilanove and Mega (using the Ethernet library coming in Arduino 0019). An SD card library is not yet included in the standard Arduino distribution, but thesdfatlibby Bill Greiman works well. Seethis tutorial from Adafruit Industriesfor instructions (thanks Limor!).
The latest revision of the shield also includes a reset controller, to ensure that the W5100 Ethernet module is properly reset on power-up. Previous revisions of the shield were not compatible with the Mega and need to be manually reset after power-up. The original revision of the shield contained a full-size SD card slot; this is not supported.
Arduino communicates with both the W5100 and SD card using the SPI bus (through the ICSP header). This is on digital pins 11, 12, and 13 on the Duemilanove and pins 50, 51, and 52 on the Mega. On both boards, pin 10 is used to select the W5100 and pin 4 for the SD card. These pins cannot be used for general i/o. On the Mega, the hardware SS pin, 53, is not used to select either the W5100 or the SD card, but it must be kept as an output or the SPI interface won't work.
Note that because the W5100 and SD card share the SPI bus, only one can be active at a time. If you are using both peripherals in your program, this should be taken care of by the corresponding libraries. If you're not using one of the peripherals in your program, however, you'll need to explicitly deselect it. To do this with the SD card, set pin 4 as an output and write a high to it. For the W5100, set digital pin 10 as a high output.
The shield provides a standardRJ45ethernet jack.
The reset button on the shield resets both the W5100 and the Arduino board.
There are no product questions yet.
Excl. VAT: £19.50 Incl. VAT: £23.40
The Arduino Uno has 14 digital input/output pins, 6 analog inputs, a U...
Excl. VAT: £5.00 Incl. VAT: £6.00
The ProtoShield mates with the Arduino board and provides a small sold...
Excl. VAT: £17.00 Incl. VAT: £20.40
This is a motor shield for Arduino that will control two DC motors. Ba...
Excl. VAT: £16.00 Incl. VAT: £19.20
The Color LCD Shield provides an easy method of connecting the popular...
Excl. VAT: £4.00 Incl. VAT: £4.80
This is a Breakout Board for the 'Hall Effect' based linear ACS712 Cur...
Excl. VAT: £55.00 Incl. VAT: £66.00
DISCONTINUED - This Arduino Inventors kit is a great way to get starte...