Conductive thread kit (with batteries) – pack of 5

This kit is supplied ‘pre-built’ so requires no soldering. It is sold in packs of five kits in a panel with around ten metres of the conductive thread. Each kit comprises three small PCB’s that can easily be cut out of the panel and are then ready for use. The largest of the three PCB’s holds an LED plus the control electronics, battery and a push button. On both of the remaining PCB’s there is an LED, which are connected to the main board with conductive thread.

Pressing the button cycles through the following patterns: all LEDs constantly on, slow flash all on all off, fast flash each in turn and turned off. The device features auto off, which turns the unit off after 30 minutes to preserve battery life. The battery is included and depending upon flash pattern lasts for approximately two days of constant use.

 

Lithium 3V coin cell CR2032 200mA/h

Strip of 5